Cellwrite Studio operating manual · CWS-OM-001, revision A
Troubleshooting
Opening backups
| Problem | Cause | Action |
|---|
| The backup opens with no programs. | The folder selected is not the backup's top folder. | Select the folder that holds RAPID, SYSPAR and BACKINFO. |
| Names are marked as unknown. | A module opened on its own uses names from other modules. | Open the whole backup. Names are marked as unknown only when the whole program is open. |
| Instructions of an option are marked as unknown. | The option is not listed in the backup. | Check that the backup is complete. Report it with Help > Report a problem if it is. |
The 3D view
| Problem | Cause | Action |
|---|
| The 3D view is slow or blank. | The graphics card does not offer Direct3D 11, or its driver is old. | Update the graphics driver. Cellwrite Studio draws with its own renderer when Direct3D is not there. |
| The robot is not where it stands in the cell. | Its base frame is not in the backup, or the cell layout placed it from a shared work object that disagrees. | Place it by hand in Cell > Layout. |
| A tool looks wrong. | The tool is built from its tool data, payload and SafeMove shapes. | Check the tool data in the backup. |
Live connection
| Problem | Cause | Action |
|---|
| Connect finds no robots. | The computer is not on the robots' network, or the wrong adapter is searched. | Check the computer's address and Settings > Live connection. |
| A robot is found but does not connect. | The controller refuses the user, or a firewall blocks the port. | Ask the site's network administrator. |
| Write access is not granted. | The request was not granted on the FlexPendant, or the robot is in automatic mode. | Ask the operator to grant it. |
| Recorded moves look jerky. | Readings were lost on a busy network. | Record over a wired connection. The recording plays through short gaps. |
Licence and sign-in
| Problem | Cause | Action |
|---|
| The browser does not open. | No default browser is set. | Open the address shown in the window by hand. |
| Sign-in says the licence is in use on all its computers. | The licence is used on as many computers as it covers. | Release a computer in Account > Computers. |
| Cellwrite Studio asks to be connected. | The licence has not been checked for too long. | Connect to the internet once. |
Getting help
If a problem is not listed here, select Help > Report a problem. See Problem reports and support.