Cellwrite Studio operating manual · CWS-OM-001, revision A

Cellwrite AI

Cellwrite AI answers questions about the programs, the cell and the PLC program open in Cellwrite Studio, and can make changes to the programs for you.

Asking a question

  1. Select Assistant on the right of the window, or press Ctrl+I.
  2. Type the question and press Enter.
  3. The answer appears as it is written. Names of routines, points and rungs in the answer are links: select one to go to it.

Cellwrite AI is told what is open: the program and the routine in front, the cell's layout, a recording that plays, the PLC routine shown. Ask about what you see, for example:

  • "What does this routine do?"
  • "Why does R02 wait at this line?"
  • "Which robot is holding up the cell?"
  • "What sets this PLC bit?"

Changes made by Cellwrite AI

When you ask for a change, Cellwrite AI makes it in the editor, where you can see it.

  • Each change is shown in the editor and in the Changes panel before anything is saved.
  • One Ctrl+Z takes back a change made by Cellwrite AI.
  • It can add a new module to the program.
  • It can fill an Excel template from the program, for example a point list.

Caution

Read every change before you save it. Check the program with Check program (F8) afterwards.

Conversations

Earlier conversations are kept and can be opened again from the list in the Assistant panel. To tell Cellwrite about a wrong answer, right-click in the conversation and select Send to Cellwrite.

What is sent

Cellwrite AI runs through Cellwrite's own AI service. When you ask a question, the parts of your programs needed for the answer are sent to the AI model provider, which uses them only to answer and does not use them to train its models.

Each licence has a fair-use allowance. Account > AI allowance shows how much of it is left and when it starts again.