Cellwrite Studio operating manual · CWS-OM-001, revision A
Introduction
What Cellwrite Studio is
Cellwrite Studio is a program for robot programmers. It opens robot backups, shows the programs in an editor that knows the robot language, and checks them. It plays the programs in 3D, places the robots of a cell together, and finds where two robots can collide. It connects to robots and PLCs on the network to watch the cell run and to record it.
Cellwrite Studio works with ABB robots (IRC5 with RobotWare 6, OmniCore with RobotWare 7) and FANUC robots. It reads Rockwell PLC programs exported from Studio 5000 as L5X files.
The window
| Part | What it holds |
|---|---|
| Ribbon | The commands of the workspace in front, in tabs across the top. |
| Workspaces | Code, Points, Cell, Compare, Live and PLC: one for each kind of work. Ctrl+1 to Ctrl+6 go to them. |
| Explorer | The backups open, with their tasks, modules and routines. |
| Editor | The modules open, one tab each. |
| Inspector | What the cursor is on: a point, a tool, a work object, a signal. |
| Outline | The routines and data of the module in front. |
| Problems | What Check program found, and errors found while you type. |
| Changes | What has changed in the backup since it was opened. |
| Assistant | Cellwrite AI, which answers questions about the programs open. |
| 3D view | The program played in 3D, in a tab of its own. |
| Status bar | The robot connected, the licence and the size of the window's text. |
The File tab holds Start, Info, Save, Close backup, Account, Settings and About.
Panels
Every panel can be closed, moved and docked. View > Panels brings a closed panel back. View > Reset layout puts every panel back where it started.
Tip
View > Larger and Smaller (Ctrl+Alt+= and Ctrl+Alt+-) change the size of all text and controls together.
System requirements
| Item | Requirement |
|---|---|
| Operating system | Windows 10 or Windows 11, 64-bit |
| Memory | 8 GB. 16 GB for recordings of a whole zone. |
| Graphics | Direct3D 11 for the 3D views. Without it a software renderer is used. |
| Network | Ethernet to the robot controllers and PLCs for the live functions |
| Internet | For activating the licence and for Cellwrite AI |
Installing
- Run the installer.
- Follow the steps. Tick Open ABB (.mod .sys .prg .cfg) and FANUC (.tp .ls .pc .va .vr .sv .dg) files to open them in Cellwrite Studio from Windows Explorer. A file opens with the backup it belongs to: a program in the editor, a KAREL program or a register file on its page. Without the tick, Help › Register file associations does the same later.
- Start Cellwrite Studio from the Start menu.
- Activate the licence. See Account and licence.