Cellwrite Studio operating manual · CWS-OM-001, revision A

Points

The Points workspace holds every position in the programs: robot targets, joint targets, tools and work objects. Its sections are All points, Calibrate, Convert, Joint data and Process points.

All points

A table of every point of the active robot, with its module, work object, tool and values. Select a point to see where it is used. Double-click it to open its declaration.

Calibrate

Calibrate corrects points from measurements taken in the cell. Use it when a fixture has moved, or when a work object was taught in the wrong place.

The measurements are given in the work object's frame, not in the robot's world frame.

  1. Select Points > Calibrate.
  2. Select the work object.
  3. Add the measured points: Add point, or Paste measured to paste a table from Excel. Add work object points adds the points the work object's frame was taught with.
  4. Select Run calibration. The result says how far each point moves and how well the measurements agree.
  5. Select Apply to the program. By default the work object is corrected and the points keep their path.

Only the numbers of the points and the work object are changed in the program. The rest of each line stays as it was.

Caution

Check the result with the robot at reduced speed before running the program in production.

Convert

Convert moves points from one work object or tool to another, keeping where the robot goes.

  1. Select the points to convert.
  2. Select the work object and tool to convert them to.
  3. Select Apply to backup.

Advanced holds the options for points with external axes and for configuration data.

Joint data

Joint data finds the robot's axis angles at each point, as the robot would reach them. Find joints works on the active robot; Scan whole zone on every robot open. Export writes the table to Excel.

Joint data is hidden by default. Show it with Settings > Programs > Show Joint data in Points.

Process points

Process points lists the points where the program does its work: weld spots, rivets, glue lines. They are found from the process instructions and the routines that call them.

  • Apply to editor writes changes made in the table back into the program.
  • Export to Excel writes the table to an Excel workbook.
  • Record panel shows what the process signals did during a recording.