Cellwrite Studio operating manual · CWS-OM-001, revision A
Live connection
This chapter describes connecting to robots on the network: watching them, backing them up, changing their programs and recording the cell.
Before you connect
- The computer is connected to the robots' network by Ethernet.
- The controllers run RobotWare 6 or RobotWare 7. Robot Web Services, which Cellwrite Studio uses, is part of both.
- The network addresses of the robots are known, or the robots answer on the network so that Connect finds them.
Note
Cellwrite Studio never changes a robot's or a PLC's network settings. If this computer is not on the robots' network, the Connect window can give it an address there: Set up for the cell network, or Own address for one you type. Restore puts this computer's connection back as it was.
Connecting
- Select Live > Connect.
- The robots found on the network are listed. Select one or more.
- Select Connect. Each robot opens with its program, as if its backup had been opened.
Which network adapters are searched is set in Settings > Live connection.
What you see
| View | What it shows |
|---|---|
| Robot 3D | The robot as it moves now, with its tool. |
| I/O | The robot's signals and their values now. |
| Event log | The controller's event log, newest first. Select a message to read its cause and actions. |
| Tasks | The controller's tasks, their state and their program pointers. |
The editor follows the robot's program pointer while the program runs.
Write access
Cellwrite Studio only reads from a robot until it is given write access. Write access is granted from the FlexPendant, so the operator at the robot always decides.
- Select Request write access: in the top bar, on the live strip above the editor, or Live > Access.
- On the FlexPendant, the operator grants the request.
- While Cellwrite Studio holds write access, the robot's chip in the top bar turns amber and reads write access, and Release write access sits beside Apply.
- To give it back, select Release write access: in the top bar, on the live strip or Live > Access. Changes not yet on the robot are applied first, after you confirm. Write access is also released when you disconnect.
Caution
While Cellwrite Studio holds write access, the FlexPendant cannot change the program. Release write access when you have finished.
Applying changes
- Change the program in the editor as you would a backup.
- Select Live > Apply. Cellwrite Studio reads the robot's program again, says what it will change, and sends only the modules you changed.
- Undo last apply puts back the modules as they were before the last apply.
A new module is loaded beside the existing ones. A module changed on the FlexPendant since it was read is not overwritten without a warning.
Backing up a robot
Live > Back up robot makes a backup in the robot's own backup folder, named as the FlexPendant names its backups. It can then be opened like any other backup.
Recording the cell
A recording keeps what every connected robot did: its axes, its program pointer, its signals and its events. It plays back in Cell > Layout as if live.
- Connect to the robots of the cell.
- Select Live > Record.
- Select Stop recording when you have recorded enough.
Recordings are kept in your Documents folder, and Recordings in Cell > Layout lists them. While recording, Look back plays what has been recorded so far, and Live returns to the cell now. Mark (Ctrl+M) marks a moment to come back to.
Tip
Recordings > Save as a web page writes a recording as one HTML file that plays the cell in 3D in any web browser, on a phone too.
Site mode
Settings > Live connection sets how recordings are made:
- Commissioning: record by hand. Recording starts and stops when you select it.
- Site: record every cell, always. Every connected cell is recorded in segments, and old segments are archived.
Line dashboard
Live > Line dashboard shows the connected robots and the cell's PLC in a window of its own: each robot's state, cycle, faults and what it waits for. It only reads.