Cellwrite Studio operating manual · CWS-OM-001, revision A

Glossary

TermMeaning
BackupThe folder a robot controller writes with its programs, system parameters and system files.
CellA group of robots, fixtures and a PLC that work on the same parts.
Check programThe check of every module of a program together, as the controller makes when it loads a program.
Collision modelSpheres and boxes round a robot's arm, tool and payload, used to measure distances.
Interlock zoneA space two robots share. A robot asks for the zone before it enters and releases it when it leaves.
L5XThe XML file Studio 5000 exports a Rockwell PLC project to.
ModuleA file of RAPID code: a program module (.mod) or a system module (.sys).
Motion pointer (MP)The move the robot makes now.
Program pointer (PP)The instruction the program runs next.
RAPIDThe programming language of ABB robots.
RecordingWhat the connected robots did over a time: axes, program pointers, signals and events.
Robot Web ServicesThe interface ABB controllers offer on the network, which Cellwrite Studio uses to read and change them.
SafeMoveABB's safety controller option, which limits where and how fast a robot moves.
TaskA program that runs on a controller beside others. A robot's motion task is usually T_ROB1.
TCPTool centre point: the point of the tool the robot moves.
Tool dataThe tool's frame, weight and centre of gravity, as the program declares it.
TPThe programming language of FANUC robots' teach pendant programs.
Work objectA frame the robot's points are taught in, usually fixed to a fixture.
Write accessThe right to change a controller's program, granted from the FlexPendant.